Yes, customized drawing or specification is available, just send us your requirements.We need to know the specification in details, and then we need to check with our technology department. We will give customers satisfying reply as soon as possibleBrowse Qihang products
About cutting: our factory is equipped with 3 large block cutting machine and 2 large bar cutting machines , which can process various special-shaped shapes.About customized size and color: our factory is equipped with professional research and development team and technical personnel.Browse Qihang Products
Qihang Rubber specializing in the production of EPDM, NBR, SBR, CR rubber sheet, rubber mat, rubber block, PVC sheet, cow mat, horse stall mats,etc.Browse Qihang Rubber ProductsRubber mats are used in cars, workplaces and homes.They provide an anti-slip surface, and protect carpeting from mud and slush.If you plan to use a lot of these mats, it may be more cost effective to purchase one, then make a mold and cast your own copies out of molding rubber. The process is not complicated, and is referred to as a bucket mold.Step 1Place the mat onto a large piece of plastic or Plexiglas. The surface should be at least three inches larger than the mat, on all sides. Secure it in place with hot glue.Step 2Assemble a box of 1-by-4 boards around the mat, leaving one inch of empty space, between the mat and boards, on all sides. Glue the box together with hot glue, as it is a temporary structure.Step 3Use hot glue to attach the box to the plastic surface. Step 4Seal all the joints, where cement may leak, with hot glue.Step 5Allow the glue to cool.Step 6Brush the mat, plastic surface, and interior of the box with a thin coat of petroleum jelly.Step 7Mix a fine-grain gypsum such as Ultracal 30, or Hydrocal with water, following the instructions on the package. These materials are inexpensive, so make more than you think you will need.Step 8Pour the gypsum into the mold, covering the highest point on the mat by one inch.Step 9Tap the sides of the mold and the surface of your work table with a rubber mallet. The vibrations will dislodge any trapped air bubbles, causing them to rise to the surface.Step 10Allow the gypsum to cure. It will go through an exothermic heating and cooling process. This may take up to two hours.Step 11Remove the wood from the gypsum and pull out the rubber mat. You now have a mold of the mat, into which you can pour liquid rubber, to make additional copies.
We manufacture multiple products and we offer so many types of mats and rubber sheet that we can't list them all on the website, so if you don't see what you are looking for, Please contact us. Email: postmaster@qihangrubber.com